Call these folks,,They are an authorized QC dealer and repair shop. They are top notch with Qualcomms,,they had a Field day with the way Aluimi-Bunk installed mine and completely gutted it and started over a few years ago.. I'm sure they will answer your Q's over the phone,, then call your carrier to see bout getting it worked on. Ill deadhead there before letting Aluimi-bunk work on my wiring again.
PJs Fabricating
1511 Linwood AVE. SW.
Canton Ohio 44710
330-478-1120
PJs? Give me a break. I had them install QualComms in two of my vehicles and both had lots of problems until a competent shop put on good stuff.
Believe me, I would have done a better job myself.
4 years ago they butchered my wires in my van AFTER I told them where thy need to hook it up. Remember, I came from another company, and I already had a QualComm installed. Everything was there, no need to cut into anything else. But what do I know, I am just a stupid truck driver. When I got home and I looked at what hey did, I felt like crying.
Then 2 months ago in my tractor trailer they installed the QualComm, I leave down the road and the stinking thing has the NO SIGNAL light on for 90% of the time. Went to another place and they replaced the dome. I looked at the dome that PJs installed and it was so rusted, why in the hell did they even put it on? Not to mention that they installed my signs too, and they are peeling already. Oh, and they switched 2 numbers, instead of E8645 they put E8654. I would avoid PJs as the plague. Wish FedEx will give us a choice if we want it installed somewhere else.