Search results

You're going to love this, I lifted my bed up, unplugged the sensor, plugged it back in and I was able to do a reset on the abs not the abs light is gone, but still have the beautiful brake light that will disappear by morning on its own, I already have a sensor, I'm just going to have it keep...

D type is what's on it, sensor is just a plug and play without special tools needed correct?

by the fuses, don't see a abs ecu, unless I'm mistaken

How would I know which one I have exactly? D says it's the left rear, while e says it's the right rear

Abs also now blinks 4-3 after I disconnected the rear pass sensor and reconnected it

Abs came back on 4-4 on the flashes, then when I try to reset it it flashes 1-2

That's what looks like happened here, water has gotten inside on the connector from the hood to the chassis but nothing on the connection from the chassis, would you recommend just replacing both of those or just the one from the hood, and taking the one from the chassis off and making sure...

I appreciate the diagram, but I figured out its something with the wiring from the chassis to hood, I unplugged and replied it in again, rechecked to see if there's power and all good, had the blinkers on while I was doing this, and as I'm plugging it back in it turns on, then immediately stops...

To be honest I found it when I was diagnosing the brake aux motor, it was sitting on a panel under it. If that's where the air box is located I'll have to look into it and see if it's from it. Has power at the socket, plug between hood and chassis has some build up, but nothing that's where...

I'm guessing it's this tube? Also one last small problem I'm having is the left turn signal in the front won't work, it has power and the light is good, just won't turn on when I put the signal to turn left.

Neither do I specially with the cost of some of them, picked the truck up today no brake light, gone on its own, didn't do a single thing. But we have a water leak inside, and yes the air condition is on

Also pulled the relay off, and I'm not getting a single reading from it I'm assuming my relay is bad

Unless I'm doing this wrong this is what I'm getting. I'm guessing it's the one that I have unplugged, if it is I'm getting power from it at 6 and 12 v Getting continuity Not getting anything

Figured that, where is the motor located exactly?

Perfect I'll grab one. I just noticed that it does not, I turned the truck off then back on, and don't hear the motor, usually when the truck is in the on position and not started and I press the brake, the pedal will go down, but it doesn't go down now, and I don't hear the motor working.

Perfect, I'd just need a circuit tester like the one in the pic?

I'll look it up. I'm going to be 100% honest diesel trucks and fixing them myself is all new to me, so how would I get rid of this brake light, what tests would need to be done if any to figure out which switch is going bad?

What are the chances that's the reason the brake light came on? How do I get it back to the second position? What are the chances this is the only reason the brake light is on?

This little switch by the brake pedal, should it be in the position in the first pic or second pic?

All fluids are full, still haven't had a chance to test the fuel sensor I'm thinking it's going bad since it attempted to read the fuel level and read one bar of fuel then started saying low fuel again.