Anyone run them on single rear axle?
That would be a bad idea. Atleast on a dual wheel axle you can limp in on the other wheel/tire. If you have s/s on a single axle you arent going anywhere if you have flat.
How far did ya limp the last time a steer tire blew, Jake?
I believe there are tons of myths out there from the first generation of singles.
FWIW, Dave, Michelin's got an app for that. I think you'd be surprised at how widely available they are. Not sure who pays fuel in your operation, but in ours (1 truck for now), they pay for themselves between 6 and 7 months. We paid $2250 for the tires, and swapped even-up for rims/mount/balance for our dual rims and casings with about 10/32 remaining.
Ours is a single rear axle, with a liftable in front of the drive. We can load about 6k in the box without dropping the scond axle. They have smaller duals on them. When the wide singles wear down quite a way, we will move them to the lift able, and put new singles on the drive axle. Based on DD's posts, it may be a long wait. May end up doing it before that....just because I'm impatient.
Ours is a class 7 Sterling.
Never blown out a steer usaf. That is not what I'm saying here. If a steer blows your down but with split rears on a single axle you can limp it in. The company I used to work for had them on tractors and trailers and I had one blow on the tractor and it just taco my wheel.
You guys are doing it and it's fine if your happy with them and that's great I just wouldn't feel comfortable with the on a single axle.
Mayfield Express
Sent from my iPhone using Tapatalk
I heard on one of the trucking shows that trucks that are not designed to have supersingles sometimes have trouble with axles after a while. Has anyone else heard anything about this or had a problem with axles wearing funny after putting on these tires?
Just have to make sure you have the proper offset on your rims, Joe.
There are several reports on them causing premature outer axle bearings to wear out.