Search results

  1. jjoerger

    06 vs 07

    What are the differences between an 06 and 07 model year motors on an MBE 4000? Sent from my EVO using EO Forums
  2. jjoerger

    Tensioner Pulley's

    A few nights ago we stopped at a rest area and heard a noise coming from the front of our MBE4000 engine. It was a grind, pause, grind, pause type of sound. The AC was off and we could not tell where the sound was coming from. The noise went away but now there is a lot of vibration when the...
  3. jjoerger

    Broken Windshield

    We had a windshield crack last Wednesday on a run to Florida. Safelite came by the house on Friday and installed a new one. We are now in Monroe, MI where it is raining and our new windshield is leaking quite a bit from the top. Guess I'll break out the duct tape once it dries up and see if I...
  4. jjoerger

    Rotate and Balance Drive Tires

    How often do you rotate and balance your drive tires? We have 60,000 miles on this set and one inside tire is showing some odd wear on the inside tread.
  5. jjoerger

    Steering wheel jumpy from new brakes?

    We had new brakes put on the steers yesterday and I noticed after we picked up the truck that the steering wheel is quite jumpy during hard braking. Such as coming off the interstate onto the ramp. Is it common for the brakes to need to wear in a little bit? The drums were not resurfaced.
  6. jjoerger

    Strong sulpher odor

    I keep smelling a strong sulpher odor coming from our truck. Last place we fueled was TA in Oregon. Any ideas? Sent from my PG06100 using EO Forums
  7. jjoerger

    Lift Gate with Swing Doors

    I am having my lift gate installed tomorrow. It has a rear deck extension, but I have swing doors. My locking mechanism is below the height of the deck extension. How do I close and lock my rear doors? Is there a cut out in the extension or does the lock have to be changed? It is being...
  8. jjoerger

    2500# Capacity Lift Gate?

    Will a 2500# capacity lift gate do the job for expediting? I know bigger is better but I may have found a good deal on a used Maxon.
  9. jjoerger

    Stretched sleeper pick up truck

    I saw this truck in Illinois. Wonder how long it will be before it sags.
  10. jjoerger

    Kenworth T680

    The new Kenworth T680 Kenworth Trucks - The World's Best® I wonder if they will build it as a straight truck?
  11. jjoerger

    Chipped windshield repair

    Has anyone ever used the stuff they sell in truck stops to repair a chipped windshield? The one we have is a pea size.
  12. jjoerger

    Mercedes MBE 4000 Glow Plugs?

    Does a 2006 Mercedes MBE 4000 have glow plugs? I had to do a cold start this morning and I was beginning to think it wasn't going to start. Should have plugged in the block heater.
  13. jjoerger

    Wanted: Used lift gate

    Anyone know of a good place to get a used lift gate? I would prefer a 4500 pound capacity tuck away style and installation.
  14. jjoerger

    Voltage read out

    Normally our digital voltage read out stays at 13.9 while driving and 14.1 while idling. The last two days the voltage has dropped as low as 12.8 while running and seems to fluctuate from 13.7 down to 13.2 a lot. At idle it stays at 14 to 14.1. All batteries tested good. The alternator is...
  15. jjoerger

    Sprinter vs Cargomaxx

    Has anyone done a cost of ownership comparison between these two vehicles? If you were to purchase both new, run them 500,000 miles and then sell them, which one would cost more to own? I know the Sprinter costs more to purchase and maintain, but it also gets better MPG's and may last...
  16. jjoerger

    Truck Battery Question

    Our 2006 Columbia has 4-1010 CCA batteries that are 19 months old. I had them tested a few weeks ago and one was not as strong as the other three, but I was told it would be OK. Yesterday they were fully charged. This morning after the truck sat for 22 hours with just the fridge running it...
  17. jjoerger

    Signage and Qualcomm Removal

    Yesterday my wife and son removed all our FedEx signage using a heat gun. Today we used Goof Off to remove the glue. Now our box has nice clean areas where we used the Goof Off and really nice shadows from the old signage. Guess there is not much we can do short of having the box repainted...
  18. jjoerger

    Slush Busters question

    One of our Slush Busters is coming loose at the end. Does anyone know how to re glue it? They were just installed 2 weeks ago.
  19. jjoerger

    Lift Gate Lift Axle

    It looks like I will have the money soon to add either a lift gate or a lift axle. Our truck has a 24 foot box, is double framed and has a 450 HP engine. But we only have a 10,500 pound capacity. A lift axle would raise our weight capacity and allow us to haul heavier freight. But, it seems...
  20. jjoerger

    New Seats

    We wanted new seats for our truck so we saved our T Chek rebates for 6 months and bought new ones this month. teamjdw told us to contact http://www.superior-seats.com to check out the deals they had. We got 2 Excalibur leather http://www.superior-seats.com/seats/excalibur_big.jpg seats with...
Top